Juniper Networks EX3200 Manuel d'utilisateur télécharger pdf (Page 189)

redirected to the new management IP address. If the connection cannot be made,

the J-Web interface displays instructions for starting a J-Web session.

Related Topics ■ Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 163

■ Installing and Connecting an EX2200 Switch

■ Installing and Connecting an EX3200 or EX4200 Switch on page 113

■ Installing and Connecting an EX8208 Switch

■ Installing and Connecting an EX8216 Switch

Connecting and Configuring an EX Series Switch (J-Web Procedure)

There are two ways to connect and configure an EX Series switch: one method is

through the console using the CLI and the other is using the J-Web interface. This

topic describes the J-Web procedure.

To run the ezsetup script, the switch must have the factory default configuration. If

you have configured anything on the switch and want to run ezsetup, revert to the

factory default configuration. See Reverting to the Default Factory Configuration for

the EX Series Switch.

To connect and configure an EX Series switch using the J-Web interface:

1. Connect the Ethernet cable from the Ethernet port on the PC to the switch.

■

EX2200, EX3200, or EX4200 switch—Connect the cable to port 0 (ge-0/0/0)

on the front panel of the switch.

■

EX8200 switch—Connect the cable to the port labeled MGMT on the Switch

Fabric and Routing Engine (SRE) module in slot SRE0 in an EX8208 switch

or on the Routing Engine (RE) module in slot RE0 in an EX8216 switch.

These ports are configured as the DHCP server with the default IP address,

192.168.1.1. The switch can assign an IP address to the management PC in the

IP address range 192.168.1.2 through 192.168.1.253.

NOTE: The switch will transition into initial setup mode only when the switch is in

the factory default configuration.

2. Transition the switch into initial setup mode:

■ EX2200 switch—Press the mode button located on the lower right corner

of the front panel for 10 seconds.

■

EX3200, EX4200, or EX8200 switch—Use the Menu and Enter buttons located

to the right of the LCD panel (see Figure 66 on page 164):

Connecting and Configuring an EX Series Switch (J-Web Procedure) ■ 163

Chapter 12: Performing Initial Configuration

1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 283 284

Pas de commentaire

Juniper Networks EX3200 Manuel d'utilisateur Page 189