Juniper Networks EX3200 Manuel d'utilisateur télécharger pdf (Page 176)

3. Remove the screw securing the terminal block cover using the

Phillips (+) screwdriver, number 2 and remove the terminal block cover (see

Figure 57 on page 150). Save the screw.

Figure 57: Removing the Terminal Block Cover from a DC Power Supply in an EX3200

or EX4200 Switch

4. Remove the screws on the terminals using the Phillips (+) screwdriver, number 2.

Save the screws.

WARNING: Ensure that the power cables do not block access to switch components

or drape where people can trip on them.

5. Connect the power supplies to the power sources. Secure power source cables

to the power supplies by screwing the ring lugs attached to the cables to the

appropriate terminals by using the screw from the terminals (see Figure 58 on

page 151).

■ To connect a power supply to a power source:

a. Leave the jumpers on the power supply terminals in place.

b. Secure the ring lug of the positive (+) DC power source cable to the A+

or B+ terminal on the DC power supply.

c. Secure the ring lug of the negative (–) DC power source cable to the A–

or B– terminal on the DC power supply.

d. Tighten the screws on the power supply terminals until snug using the

Phillips (+) screwdriver, number 2. Do not overtighten—apply between

8 lb-in. (0.9 Nm) and 9 lb-in. (1.02 Nm) of torque to the screws.

If you have a second installed power supply, connect it in the same way you

did the first.

■ To connect one power supply to two power sources:

150 ■ Connecting DC Power to an EX3200 or EX4200 Switch

Complete Hardware Guide for EX3200 and EX4200 Ethernet Switches

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 283 284

Pas de commentaire

Juniper Networks EX3200 Manuel d'utilisateur Page 176