Juniper Networks EX3200 Manuel d'utilisateur télécharger pdf (Page 178)

Connecting an EX Series Switch to a Network for Out-of-Band Management

You can monitor and manage an EX Series switch using a dedicated management

channel. EX Series switches have a management port with an RJ-45 connector for

out-of-band management. Use the management port to connect the EX Series switch

to the management device.

Ensure that you have an Ethernet cable with an RJ-45 connector available. One such

cable is provided with the switch. Figure 59 on page 152 shows the RJ-45 connector

of the Ethernet cable supplied with the switch.

Figure 59: Ethernet Cable Connector

To connect an EX Series switch to a network for out-of-band management (see Figure

60 on page 153):

Connect one end of the Ethernet cable to the management port (labeled MGMT)

on the EX Series switch.

For the location of the MGMT port on different EX Series switches:

■ See Rear Panel of an EX2200 Switch.

■ See “Rear Panel of an EX3200 Switch” on page 9.

■ See “Rear Panel of an EX4200 Switch” on page 11.

■ See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch.

■ See Routing Engine (RE) Module in an EX8216 Switch.

2. Connect the other end of the Ethernet cable to the management device.

152 ■ Connecting an EX Series Switch to a Network for Out-of-Band Management

Complete Hardware Guide for EX3200 and EX4200 Ethernet Switches

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 283 284

Pas de commentaire

Juniper Networks EX3200 Manuel d'utilisateur Page 178