Juniper-networks Juniper M-series M10i Manuel d'utilisateur télécharger pdf (Page 69)

SONET/SDH OC12/STM4 (Multi-Rate) PIC with SFP

■

JUNOS 8.4 and laterSoftware release

■

Rate-selectable using one of the following rates:

■

1-port OC3

■

1-port OC12

■

1-port OC12c

■

Power requirement: 0.20 A @ 48 V (9.5 W)

Description

■

Multiplexing and demultiplexing

■

Rate policing on input

■

Rate shaping on output

■

Packet buffering, Layer 2 parsing

Hardware features

■

Optical diagnostics and related alarms

■

Per-port SONET/SDH framing

■

Link aggregation

■

Alarm and event counting and detection

■

Dual-router automatic protection switching (APS)

■

Multiprotocol Label Switching (MPLS) fast reroute

■

Encapsulations:

■

High-Level Data Link Control (HDLC)

■

Frame Relay

■

Circuit cross-connect (CCC)

■

Translational cross-connect (TCC)

■

Point-to-Point Protocol (PPP)

Software features

You can install any transceiver supported by the PIC. For information about installing and

removing transceivers, see the PIC and Transceiver Installation Instructions.

■

Duplex LC/PC connector (Rx and Tx)

■

Optical interface support—See Table 18 on page 71 and Table 19 on page 71

NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid

links, take the PIC offline until you are ready to establish a link to another device. For

information about taking a PIC offline, see the request chassis pic offline command in the

JUNOS System Basics and Services Command Reference.

Cables and connectors

SONET/SDH OC12/STM4 (Multi-Rate) PIC with SFP ■ 69

SONET/SDH OC12/STM4 (Multi-Rate) PIC with SFP

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 77 78

Commentaires sur ces manuels

Pas de commentaire

Juniper-networks Juniper M-series M10i Manuel d'utilisateur Page 69

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Juniper-networks Juniper M-series M10i