Juniper-networks Juniper M-series M10i Manuel d'utilisateur Page 52

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 78
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 51
You can install any transceiver supported by the PIC. For information about installing
and removing transceivers, see the PIC and Transceiver Installation Instructions.
NOTE: Do not install SONET/SDH SFPs in the Gigabit Ethernet port. The port will not recognize
the SFP.
Fiber-optic small form-factor pluggable transceivers (SFPs):
Duplex LC/PC connector (Rx and Tx)
Optical interface supportSee Table 11 on page 52
Copper 1000Base-T SFPs:
Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45
connector
Pinout: MDI crossover
Length: 328 ft/100 m
Cables and connectors
OK LED, one tricolor:
OffPIC is offline and it is safe to remove it from the router.
GreenPIC is operating normally.
AmberPIC is initializing.
RedPIC has an error or failure.
APP LED, one bicolor:
OffMonitoring application is not running.
GreenMonitoring application is running under acceptable load.
Port LEDs, one per port:
OffPort is not enabled.
GreenPort is online with no alarms or failures.
LEDs
Table 11: Optical Interface Support for Gigabit Ethernet IQ2 PICs with SFP
1000Base-LH1000Base-LX1000Base-SXParameter
Single-modeSingle-modeMultimodeOptical interface
SFPSFPSFPTransceiver type
Multivendor
agreement
IEEE 802.31998IEEE 802.31998Standard
9/125 SMF cable:
43.5 miles/70 km
9/125 SMF cable:
6.2 miles/10 km
62.5/125 or 50/125
MMF cable:
1804.5 ft/550 m
62.5/125 MMF cable:
656 ft/200 m
50/125 MMF cable:
1640 ft/500 m
Maximum distance
1480 through 1580
nm
1270 through 1355
nm
770 through 860 nmTransmitter
wavelength
52 Gigabit Ethernet IQ2 PIC with SFP
M10i Internet Router PIC Guide
Vue de la page 51
1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 77 78

Commentaires sur ces manuels

Pas de commentaire