Juniper-networks M20 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Juniper-networks M20. Juniper Networks M20 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 34
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
M20 Internet Router
PIC Guide
End-of-Life PICs
Juniper Networks, Inc.
1194 North Mathilda Avenue
Sunnyvale, California 94089
USA
408-745-2000
www.juniper.net
Part Number: 530-010561-01, Revision 7
Vue de la page 0
1 2 3 4 5 6 ... 33 34

Résumé du contenu

Page 1 - PIC Guide

M20 Internet RouterPIC GuideEnd-of-Life PICsJuniper Networks, Inc.1194 North Mathilda AvenueSunnyvale, California 94089USA408-745-2000www.juniper.netP

Page 2

ATM OC3 PIC JUNOS 3.1 and laterSoftware release Two OC3 ports Power requirement: 0.49 A @ 48 V (23.7 W) Conforms to ANSI T1.105-1991 and T1E1.2/93-020

Page 3

One tricolor per port: Off—Not enabled Green—Online with no alarms or failures Amber—Online with alarms for remote failures Red—Active with a local al

Page 4 - Adaptive Services PIC

ATM OC12 PIC JUNOS 3.1 and laterSoftware release One OC12 port Power requirement: 0.43 A @ 48 V (20.8 W) Conforms to ANSI T1.105-1991 and T1E1.2/93-02

Page 5 - Adaptive Services PIC ■ 5

Alarm indication signal (AIS-L, AIS-P) Bit error rate signal degrade (BERR-SD), Bit error rate signal fail (BERR-SF) Bit interleaved parity errors B1

Page 6 - ATM DS3 PIC

Channelized DS3 PIC JUNOS 4.2 and laterSoftware release Four DS3 ports Power requirement: 0.32 A @ 48 V (15.6 W) Supports up to 28 T1 channels per por

Page 7 - ATM DS3 PIC ■ 7

Alarm Indication Signal (AIS) Bit error rate (BER) Equipment failure (Does not affect service) Excessive zeros (EXZ) Far-end Block Error (FEBE) Frame

Page 8 - ATM E3 PIC

Channelized E1 PIC JUNOS 5.1 and laterSoftware release Ten E1 ports Power requirement: 0.15 A/48 V @ 7.2 W Supports up to 24 NxDS0 channels per port D

Page 9 - ATM E3 PIC ■ 9

Channelized STM1 to E1 PIC JUNOS 4.4 and laterSoftware release Four E3 ports Power requirement: 0.32 A/48 V @ 15.3 W 63 E1 channelsDescription Each E1

Page 10 - ATM OC3 PIC

Single-mode fiber Duplex SC/PC connector (RX and TX)Cables and connectorsOne tricolor per port: Off—Not enabled Green—Online with no alarms or failur

Page 11 - ATM OC3 PIC ■ 11

E3 PIC JUNOS 3.1 and laterSoftware release Four E3 ports Power requirement: 0.47 A @ 48 V (22.5 W) Integrated DSU interoperabilityDescription High-den

Page 12 - ATM OC12 PIC

This guide provides an overview and description of the Physical Interface Cards (PICs)supported by the Juniper Networks M20 Internet router that are e

Page 13 - ATM OC12 PIC ■ 13

Alarm indication signal (AIS) Equipment failure (does not affect service) Frame error Line code violation Loss of signal (LOS) Out of frame (OOF) Yel

Page 14 - Channelized DS3 PIC

Gigabit Ethernet PIC JUNOS 3.2 and laterSoftware release One Gigabit Ethernet port Power requirement: Supports large Ethernet frame sizes for more eff

Page 15 - Channelized DS3 PIC ■ 15

Table 4: Optical Interface Support for Gigabit Ethernet PICsLH TransceiverLX TransceiverSX TransceiverPIC Type43.5 miles/70 kmreach on 9/125micrometer

Page 16 - Channelized E1 PIC

Gigabit Ethernet PIC (Quad-Wide) JUNOS 4.2 and laterSoftware release Four Gigabit Ethernet ports Power requirements: 0.40 A @ 48 V (19.2 W) Supports l

Page 17 - Channelized STM1 to E1 PIC

Status LEDs, one bicolor: Off—PIC not enabled Green—PIC is operating normally Red—PIC has an error or failurePort LEDs, one pair per port: Link—If gre

Page 18

Monitoring Services PIC JUNOS 5.6 and laterSoftware release Active traffic monitoring Power requirement: 0.19 A @ 48 V (9 W) Monitors IPv4 packets Sup

Page 19 - E3 PIC ■ 19

Multichannel DS3 PIC JUNOS 5.1 and laterSoftware release Two DS3 ports Power requirement: 0.31 A @ 48 V (14.9 W) Supports up to 128 logical customer c

Page 20 - 20 ■ E3 PIC

Far-end block error (FEBE) Parity bit (P-bit) disagreements Path priority error Alarm indication signal (AIS) Loss of signal (LOS) Out of frame (OOF)

Page 21 - Gigabit Ethernet PIC

Multilink Services PIC JUNOS 4.3 and laterSoftware release Power requirement: 0.17 A/48 V= 8 W Available versions: 4 multilink bundles 32 multilink bu

Page 22 - 22 ■ Gigabit Ethernet PIC

One bicolor: Off—PIC is offline Green—PIC is online and at least one configured bundle is operating Amber—PIC is online, but no configured bundles are

Page 23

Table 1: End-of-Life PICs Supported in the M20 Internet RouterPagePICSlots RequiredFirst JUNOS SupportPortsPIC Family and TypeATM61 slot4.34ATM DS381

Page 24

SONET/SDH OC48c/STM16 PIC (Quad-Wide) JUNOS 4.1 and laterSoftware release One OC48 port Power requirements: 0.86 A @ 48 V (41.4 W)Description Multiple

Page 25 - Monitoring Services PIC

Duplex LC/PC Connector (Rx and Tx) Optical interface support—see Table 6 on page 33NOTE: To extend the life of the laser, when a PIC is not being act

Page 26 - Multichannel DS3 PIC

SONET alarms: Alarm indication signal—line (AIS-L) Alarm indication signal—path (AIS-P) Bit error rate signal degrade (BERR-SD) Bit error rate signal

Page 27 - Multichannel DS3 PIC ■ 27

Table 6: Optical Interface Support for SONET/SDH OC48c/STM16 PICsSingle-mode Long Reach (LR)Single-mode Intermediate Reach(IR)Single-mode Short Reach

Page 28 - Multilink Services PIC

This product includes the Envoy SNMP Engine, developed by Epilogue Technology, an Integrated Systems Company. Copyright © 1986-1997, EpilogueTechnolog

Page 29 - Off—PIC is offline

Adaptive Services PIC JUNOS 6.0 and laterSoftware release Supports tunnel services. This feature is included with the PIC and does not require anindiv

Page 30

Status LED, one tricolor: Off—PIC is offline and it is safe to remove it from the chassis. Green—PIC is operating normally. Amber—PIC is initializing.

Page 31

ATM DS3 PIC JUNOS 4.3 and laterSoftware release Four DS3 ports Power requirement: 0.39 A @ 48 V (19 W) Conforms to ANSI T1.105-1991 and T1E1.2/93-020R

Page 32

Multiprotocol Label Switching (MPLS) circuit cross-connect (CCC) for leveraging ATMaccess networks Support for user-configurable virtual circuits (VC

Page 33

ATM E3 PIC JUNOS 4.3 and laterSoftware release Four E3 ports Power requirement: 0.43 A @ 48 V (20.8 W) Conforms to ANSI T1.105-1991 and T1E1.2/93-020R

Page 34

Multiprotocol Label Switching (MPLS) circuit cross-connect (CCC) for leveraging ATMaccess networks Support for user-configurable virtual circuits (VC

Commentaires sur ces manuels

Pas de commentaire