Juniper Networks ISG 2000 Manuel d'utilisateur télécharger pdf (Page 51)

Removing and Installing a Mini-GBIC Transceiver

NetScreen-ISG 2000 45

3. Using your thumb, gently press the clip ejector on top of the clip, down, then

forward. This action loosens the clip from the transceiver port.

4. Gently but firmly, pull the clip from the transceiver port.

EMOVING

AND

NSTALLING

INI

-GBIC T

RANSCEIVER

To remove a mini-GBIC transceiver from a module:

1. Push in the blue ejector (located on the underside of the transceiver) until it

locks into place, disengaging the transceiver.

2. Grasp the transceiver at both sides and firmly but gently pull the transceiver

toward you to remove it from the module.

To install a mini-GBIC transceiver into a module:

1. Grasp the transceiver with the label facing up, then insert it into the transceiver

slot.

2. Check to see if the black transceiver ejector extends fully out to the front of the

ejector slot, align it with the port portion of the transceiver.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 113 114

Pas de commentaire

Juniper Networks ISG 2000 Manuel d'utilisateur Page 51