Juniper Networks Secure Services Gateway SSG 20 Manuel d'utilisateur télécharger pdf (Page 74)

SSG 20 Hardware Installation and Configuration Guide

74 

Table 19: Fields in E1 Physical Layer Tab Window

Figure 35: E1 Frame Relay Tab Window

Table 20: Fields in E1 Frame Relay Tab Window

Field Description

Clocking Sets the transmit clock on the interface.

Frame Checksum Sets the size of checksum. Default is 16.

Framing Mode Sets the framing format. Default is without CRC4.

Idle Cycles Flag Sets the value that the interface transmits during idle cycles. Default

setting is 0x7E:

 0x7E (flags)

 0xFF (ones)

Start/End Flags Sets the transmission of start and end flags to either filler or shared.

The default is filler.

Invert Data checkbox Enables inverted transmission of unused data bits.

Time Slots Sets the use of time slots on a T1 interface. Default is 0, all 32 time

slots used.

Field Description

No-Keepalive checkbox Enables no-keepalives.

Type Sets the frame relay LMI type:

 ANSI: American National Standards Institute supports data rates

up to 8Mbps downstream and 1Mbps upstream.

 ITU: International Telecommunications Union supports data

rates of 6.144 Mbps downstream and 640 kbps upstream.

Interface Name Sets the subinterface name.

Inverse ARP checkbox Enables inverse Address Resolution Protocol (ARP) for the

subinterface.

Frame Relay DLCI Assigns a DLCI to the subinterface.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 85 86

Pas de commentaire

Juniper Networks Secure Services Gateway SSG 20 Manuel d'utilisateur Page 74