Juniper Networks IDP250 Manuel d'utilisateur télécharger pdf (Page 51)

Chapter 6

Connecting the IDP Traffic Interfaces to

Your Network and Verifying Traffic Flow

This chapter includes the following topics:

■ Guidelines for Connecting IDP Interfaces to Your Network Devices on page 35

■ Choosing Cables for Traffic Interfaces (Copper Ports) on page 36

■ Connecting and Disconnecting Fiber Cables on page 37

■ Verifying Traffic Flow on page 38

Guidelines for Connecting IDP Interfaces to Your Network Devices

We recommend you deploy the IDP appliance between gateway firewalls and DMZ

or internal networks.

Table 14 on page 35 provides guidelines for connecting IDP interfaces to your

network.

Table 14: Interface Connection Guidelines

Cable Connection GuidelinesPort

NSM must be able to reach the IDP appliance through this connection.

Connect one end of a CAT-5 cable into the MGMT port located at the front of the

chassis.

Connect the other end to a switch or hub (recommended) in your network.

Management port

Guidelines for Connecting IDP Interfaces to Your Network Devices ■ 35

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 83 84

Pas de commentaire

Juniper Networks IDP250 Manuel d'utilisateur Page 51