Juniper Networks 200 Series Manuel d'utilisateur télécharger pdf (Page 17)

Connecting the Power

NetScreen-200 Series 11

There are two ways to rack-mount the NetScreen-200 Series:

• Front mount

• Mid-mount

Front Mount

To front mount the NetScreen-200 Series device on your equipment rack:

1. Screw the front mount bracket to the side of the chassis.

2. Screw the front mount bracket to the rack, as shown below.

Mid-Mount

To mid-mount the NetScreen-200 Series device on your equipment rack:

1. Screw the mid-mount bracket to the side of the chassis.

2. Screw the mid-mount bracket to the rack, as shown below.

CONNECTING THE POWER

To connect the power supply to the NetScreen-200 Series device:

1. Plug the female end of a power cable into the male power receptacles on the back

of the system.

2. Turn the Power switch ON.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Pas de commentaire

Juniper Networks 200 Series Manuel d'utilisateur Page 17